ATIKA BKS 38 Instructions d'exploitation Page 21
- Page / 135
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
21
n in order to be able to
− , oil and
grease.
− B se the machine, the protective
perfectly and with their intended function. Only operate the
attached safety
−
of the saw
− ave to be replaced.
B
re
− Keep your tools sharp and clea
work better and safer.
Keep the handholds dry and free from resin
Check the machine for possible damage:
efore continuing to u
devices must be inspected to ensure that they work
machine with complete and correctly
equipment and do not alter anything on the machine that
could impair the safety.
Check whether the movable parts function perfectly and
do not stick or whether the parts are damaged.
All parts
must be correctly installed and fulfil all conditions to
ensure perfect operation
− Damaged guards and parts must be properly repaired or
exchanged by a recognized, specialist workshop; insofar
as nothing else is stated in the instructions for use.
Damaged or illegible security labels h
Do not allow any tool key to be plugged in!
efore switching on, check always that all tools are
moved.
Store unused equipment in a dry, locked place out of the
reach of children.
Do not carry out repair operations on the machine other
than those described in section “Maintenance” but contact
the manufacturer or authorized customer service centre
.
by the manufacturer or one of his customer service points.
Repairs to other parts of the machine must be carried out
h
Use only original spare parts, accessories and special
accessory parts. Accidents can arise for the user throug
the use of other spare parts. The manufacturer is not liable
for any damage or injury resulting from such action.
Safety instructions -
Safe handling with fuels
Fuels and fuel vapours are inflammable and may
cause serious injury on the skin or when inhaled.
Therefore be careful and provide sufficient
ventilation when handling with fuels.
Do n
Do
Stop the chain saw and allow it to cool down.
ediately
l or oil. Change your clothes
illed fuel or oil on them.
oil.
fuel
ted.
close to combustible and
om the fuelling place to start
a
ot smoke and avoid open flames when fuelling.
r gloves when fuelling.
ot fuel in closed rooms.
We
n
Avoid spilling of fuel or oil. Clean the chain saw imm
when you have spilled fue
immediately when you have sp
C Make sure that no fuel can come into the s
Carefully close the tank cap after fuelling and check that it
does not get loose during operation.
Check that there is no leakage on the tank cap and
lines. If there are leaks this product may not be star
Never use a saw with damaged ignition cable and spark
plug connector. Risk of sparking.
Only transport and store fuels in containers approved and
identified for this.
Keep children away from fuels.
Do not handle and store fuels
highly inflammable materials as well as sparks and open
flames.
Go away at least three meters fr
the chain saw.
W
W
o
o
r
r
k
k
i
i
n
n
s
s
t
t
r
r
u
u
c
c
t
t
i
i
o
o
n
n
s
s
-
-
s
s
a
a
w
w
t
t
e
e
c
c
h
h
n
n
i
i
q
q
u
u
e
e
s
s
Additional advices for sawing trunks
 Never put the trunk for sawing on the g
port the trunk in such manner that the cut does no
round.
Sup t close
e.g. sawhorse).
or saw chain.
take always the position above or
and the saw chain jams. Use a safe base (
Avoid contact to ground with the guide bar tip
Adapt shorter trunks before sawing and clamp them firmly.
Avoid cutting of thin bosk and lumber.
The chain saw is not
suitable for those works.
Carry out longitudinal cuts with special care as the claw
stopper is not used.
Avoid saw backstroke by guiding the
saw with a small angle.
When working at a slope
on the side of the trunk or the lying sawing material
respectively.
Pay attention to rolling trunks.
Notes on how to saw wood under tension
erches, trees or wood under tension becomeIf p free of tension
y sawing extreme caution is demanded.
The sawing material
juries or
b
can react completely uncontrolled and result in heavy in
death.
Such work may only be carried out by instructed
specialists.
 /  /  / Â
For all works set always first of all on the pressure side n
he releasing cut and then the dividing cut o - otherwise the
t
chai saw c jam o trike b k.
n an r s ac
Â
Upper side of wood under tensile stress
n Place one cut (one third of the diameter of the trunk) from
the bottom up.
o Then place a second cut on the same point from top which
Â
cuts through the trunk.
Underside of wood under tensile stress
bottom
n Place one cut (one third of the diameter of the trunk) from
top to bottom.
o hen place a second cut on the same point fromT
which cuts through the trunk.
 Strong trunks and strong tension
n Place one cut (one third of the diameter of the trunk) from
buttom up.
o Then place a second cut with distance to the first cut from
top which cuts through the trunk.
- BKS 38 A 1
- Beachten Si 5
- Hi Holz unter Spannung 7
- Hinweise zum Baumschnitt 7
- Mit einer richtig gespannt 8
- Schärfen der Sägekette 11
- Reinigen der Führungsschiene 11
- L ig den Kettenfänger und 12
- L Ist kein Funke zwi 12
- Erneuern 14
- nrichtungen wieder in Betr 15
- Vibrations 20
- General safety instructions 20
- - otherwise the 21
- m up (one third of the 22
- Only with a correct clampe 23
- LC d have the carburetor 27
- Compléter 33
- Respecter 34
- Coupe en étapes 36
- Contrôle du frein de chaîne 39
- Démarrage à froid 39
- Arrêter le moteur 39
- Démarrage à chaud 39
- Entretien 40
- Chaîne et guide 40
- Affûtage de la chaîne 40
- Personligt sikkerhedsudstyr 48
- LVær opmærksom p 51
- Kædesaven 51
- C Påfyld olietanken m 52
- C til rengøring, skal 52
- Rengøring 56
- Turvallisuusohjeet - Käyttö 62
- Yleiset turvallisuusohjeet 63
- Turvallisuusohjeet 64
- Lis aamiseen 64
- (1/3 osaa 65
- L Huomioi seuraavat kohdat: 66
- L K irti, moottorisaha 67
- L Kokematon 68
- uhdista poistoaukk 70
- L o säännöllisesti. P 70
- Indicazioni di sicurezza 77
- Durante l’uso della sega 77
- Indicazioni sup di tronchi 78
- L Osservare quanto segue: 80
- Vedere le indicazioni dei 81
- Affilatura della catena 83
- Regolazione del carburatore 85
- (numero di giri al minimo) 85
- Vibrasjoner 92
- Sikkerhetsinformasjoner 92
- Sagtilbakeslag 92
- Stramme sagkjedet 94
- L Ta hensyn til følgende: 95
- Vedlikehold 97
- Regulering av kjedesmøringen 97
- Sagkjede og styreskinne 97
- Sliping av sagkjedet 97
- Starten bij warme Motor 111
- Onderhoud 111
- Geleiderail reinigen 112
- Kettingwiel 112
- N1C-BL-57E (Carlton) 117
- Under sågningen 121
- - kedjesågen 122
- Endast om sågkedjan är korr 123
- L Använd aldrig kedjesåge 124
- Tankning av kedjesågen 125
- Kontroll av kedjebromsen 125
- Start av kedjesågen 125
- Fö fackman eller 126
- LDra bara 2-3 fildrag 126
- LKontrollera re 128
- Fel Möjlig orsak Åtgärd 130
© 2020, manymanuals.fr. Tous droits réservés | 1.255 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels